Researchers found a large nonlinear Hall effect in bulk EuTe4 single crystals that lasts at temperatures as high as 400 K, reports from Arxiv said.
Most previous reports of large nonlinear Hall effects were limited to low temperatures or micro- and nanoscale devices. But the signal in EuTe4 remains sizable in a bulk format through high-temperature regimes. This discovery offers a potential platform for tunable electronic devices.
A charge density wave (CDW) state drives the nonlinear Hall effect in the material. This state breaks inversion symmetry. It also forms a quasi-two-dimensional polarized structure.
The CDW state exhibits thermal hysteresis. Because of this, temperature changes can modulate the nonlinear Hall signal.
Measurements show the nonlinear Hall voltage is strongly coupled to this hysteretic state. The signal demonstrates a pronounced thermal memory effect during the transition between warming and cooling. At 340 K, the ratio of the nonlinear Hall voltages during warming and cooling is about 4.7, Arxiv reported.
Physical pressure can also alter the internal structure of the semiconductor. Researchers used a needle with a 1 μm apex radius to press against the sample. They observed a change in local optical-axis orientation, Nature reported.
This indentation creates wedge-shaped regions in the material. These regions are typically about 1 μm wide and 7 μm long. They show distinct optical contrast. This indicates a reconfiguration of the CDW-coupled polar structural domains.
Scanning electron microscopy (SEM) showed no clear cracks in most of these modified regions. There was also no permanent surface deformation. This suggests the change is not caused by simple surface damage.
Anisotropic strain affects the stability of the CDW state. Compressive strain along the a axis or tensile strain along the b axis can destabilize the state relative to the non-CDW structure. This sensitivity provides a possible basis for the mechanical reconfiguration of domains observed during indentation.
The electrical response of the material varies depending on the temperature. The second-harmonic voltage displays a quadratic dependence on the applied AC current at 100 K and 300 K. This confirms the second-order nonlinear nature of the response.
At 300 K, the transverse voltage is much larger than the longitudinal voltage when current is applied along the b-axis. High-temperature transport generally conforms to standard scaling laws.
But the reconfiguration of CDW domains can lead to a breakdown of this scaling behavior at lower temperatures. This breakdown causes a corresponding sign reversal in the signal.
The material’s structure in the CDW state is a “primitive CDW state”. The actual structure has been found to exhibit higher-order modulations, Nature reported.