Three simple maintenance tasks that you can do yourself on your car

2024-02-09 09:00:10
If you have reached the kilometers in which you have to change the oil or one of the filters, but you did not have that expense contemplated, you should not worry. It is a task that you can do yourself, assuming only the cost of the new oil bottle and filters. According to Oscaro, on a level surface, make sure you have a container for used oil, a new oil filter, and the necessary tools on hand. Always with the car cold, loosen the crankcase plug and let the used oil drain completely. If necessary, use a jack to raise the vehicle for easier access. Additionally, it is important not to rely solely on the jack for support. Once the vehicle is lifted, it is highly recommended to place it on stands for greater stability, to ensure safety while working under the vehicle. After that, remove the old oil filter and replace it with a new one. Replace the crankcase plug and tighten it properly. Finally, add new oil according to the manufacturer’s specifications. Related News standard No The ADAS that will be mandatory in a new car from July AP All newly registered vehicles must equip eight more new ones. On the other hand, to change the air filter, first open the hood and locate the box of the filter, generally near the engine and protected by a plastic cover. Unclip the clamps or remove the screws to carefully open the case. Remove the old filter and note its position to ensure proper installation of the new one. Take the opportunity to clean the box of any possible debris and place the new filter, making sure it is securely fitted. Lastly, close the cover and secure it with the clamps or screws, verifying that it is sealed correctly to prevent unfiltered air from entering the engine. Changing the battery is a task that is also accessible to any driver and is relatively simple and can be done by following the following steps. First, make sure you have a key kit and the right new battery for your vehicle. Disconnect the battery starting with the negative cable (black with “-” symbol) and then the positive cable (red with “+” symbol) to avoid short circuits. Next, unclip the old battery and place the new one in its place. Finally, reconnect the cables in reverse order, starting with the positive and making sure the new battery is securely attached. This simple process without specialized tools allows you to change the battery yourself, thus saving on the costs of replacing it in a workshop. MORE INFORMATION news No This is how the new autonomous radars are: they fine up to five times more than mobile phones news No ZBE cameras or through insurance: measures to control whether you pass the car’s MOT news No Artificial Intelligence verifies the state of the roads Even Changing burned out lights is also a very simple operation. Oscaro advises, for greater safety, to carry out this task with the vehicle off and the engine cooled. First, open the hood of the vehicle and locate the back of the headlight in question. Identify which bulb is burned out and, depending on the type, twist or unscrew the base to remove it. Disconnect the wire from the old bulb and carefully remove it. Place the new bulb (avoiding touching the glass part) and reconnect the cable, then verify that the new bulb works when you turn on the lights. Additionally, if necessary, you should adjust the alignment of the headlight to ensure correct lighting.
#simple #maintenance #tasks #car